Mechanical Properties of Fluids

In a hydraulic lift, the surface area of the input piston is 6 cm2 and that of the output piston is 1500 cm2. If 100 N force is applied to the input piston to raise the output piston by 20 cm, then the work done is kJ.

Consider following statements: Choose the correct answer from the options given below:

1. B, C, D Only
2. C, D, E Only
3. A, D, E Only
4. A, B, C Only

A 400 g solid cube having an edge of length 10 cm floats in water. How much volume of the cube is outside the water? (Given: density of water = 1000 kg m-3)

1. 400 cm3
2. 600 cm3
3. 1400 cm3
4. 4000 cm3

An air bubble of radius 0.1 cm lies at a depth of 20 cm below the free surface of a liquid of density 1000 kg/m3. If the pressure inside the bubble is 2100 N/m2 greater than the atmospheric pressure, then the surface tension of the liquid in SI unit is (use g=10 m/s2)

1. 0.02
2. 0.05
3. 0.25
4. 0.1

The amount of work done to break a big water drop of radius 'R' into 27 small drops of equal radius is 10 J. The work done required to break the same big drop into 64 small drops of equal radius will be

1. 20 J
2. 10 J
3. 5 J
4. 15 J

Given below are two statements: In the light of the above statements, choose the correct answer from the options given below

1. Both Statement I and Statement II are false
2. Both Statement I and Statement II are true
3. Statement I is false but Statement II is true
4. Statement I is true but Statement II is false

Water flows in a horizontal pipe whose one end is closed with a valve. The reading of the pressure gauge attached to the pipe is P1. The reading of the pressure gauge falls to P2 when the valve is opened. The speed of water flowing in the pipe is proportional to

1. (P1-P2)2
2. P1-P2
3. P1-P2
4. (P1-P2)4

An air bubble of radius 1.0 mm is observed at a depth 20 cm below the free surface of a liquid having surface tension 0.095 J/m2 and density 103 kg/m3. The difference between pressure inside the bubble and atmospheric pressure is N/m2. (Take g=10 m/s2)

Two soap bubbles of radius 2 cm and 4 cm , respectively, are in contact with each other. The radius of curvature of the common surface, in cm , is .

A tube of length L is shown in the figure. The radius of cross section at the point (1) is 2 cm and at the point (2) is 1 cm , respectively. If the velocity of water entering at point (1) is 2 m/s, then velocity of water leaving the point (2) will be [figure]

1. 4 m/s
2. 6 m/s
3. 2 m/s
4. 8 m/s