Current Electricity

The power dissipated in the circuit shown in the figure is 30 watts. The value of R is [figure]

1. 20
2. 15
3. 10
4. 30

In the circuit shown the cells A and B have negligible resistances. For VA = 12 V, R1 = 500 and R = 100 the galvanometer (G) shows no deflection. The value of VB is [figure]

1. 4 V
2. 2 V
3. 12 V
4. 6 V

A ring is made of a wire having a resistance R0 = 12 . Find the points A and B, as shown in the figure, at which a current carrying conductor should be connected so that the resistance R of the sub circuit between these points is equal to 83 . [figure]

1. l1l2 = 58
2. l1l2 = 13
3. l1l2 = 38
4. l1l2 = 12

If voltage across a bulb rated 220 volt-100 watt drops by 2.5% of its rated value, the percentage of the rated value by which the power would decrease is

1. 20%
2. 2.5%
3. 5%
4. 10%

In the circuit shown in the figure, if the potential at point A is taken to be zero, the potential at point B is [figure]

1. +1 V
2. -1 V
3. +2 V
4. -2 V

A current of 2 A flows through a 2 Ω resistor when connected across a battery. The same battery supplies a current of 0.5 A when connected across a 9 Ω resistor. The internal resistance of the battery is

1. 0.5 Ω
2. 1/3 Ω
3. 1/4 Ω
4. 1 Ω

If power dissipated in the 9 Ω resistor in the circuit shown is 36 watt, the potential difference across the 2 Ω resistor is [figure]

1. 4 volt
2. 8 volt
3. 10 volt
4. 2 volt

Consider the following two statements. Which of the following is correct?

1. Both (A) and (B) are wrong
2. (A) is correct and (B) is wrong
3. (A) is wrong and (B) is correct
4. Both (A) and (B) are correct

A potentiometer circuit is set up as shown. The potential gradient, across the potentiometer wire, is k volt/cm and the ammeter, present in the circuit, reads 1.0 A when two way key is switched off. The balance points, when the key between the terminals (i) 1 and 2 (ii) 1 and 3, is plugged in, are found to be at length l1 cm and l2 cm respectively. The magnitudes, of the resistors R and X, in ohms, are then, equal, respectively, to [figure]

1. k(l2 - l1) and kl2
2. kl1 and k(l2 - l1)
3. k(l2 - l1) and kl1
4. kl1 and kl2

See the electrical circuit shown in this figure. Which of the following equations is a correct equation for it ? [figure]

1. 2 - i2r2 - 1 - i1r1 = 0
2. - 2 - (i1 + i2)R + i2r2 = 0
3. 1 - (i1 + i2)R + i1r1 = 0
4. 1 - (i1 + i2)R - i1r1 = 0